RDX UHF Radios are members of the RDX Series introduced by Motorola.
Fall Protection & Fall Arrest Equipment.Industrial Safety Supplies & Protective Apparel.Data Collector Cradles and Screen Protectors.Mining, Tunneling, Monitoring & Rail Prisms.GPS Vehicle Mounts (Pickups, SUVs & ATVs).This makes people think that the speakers were intended to be compatible between these different models. The biggest problem is that the 16 pin Maxtrac speaker plugs right into the M1225. This causes the radio receive audio to have random popping noises emitted from the external speaker. It would appear that they keep trying to connect speakers with less than 8 ohms impedance. Some people are running into trouble using external speakers on their new M1225 mobiles. If you are interrested, Scholer-Johnson (SJI) can be contacted at (407) 645-5093, the boards should be about $85.
The caveat is that you must use the software that goes with the newer board (OPT-1225-PP), regardless of which board you are physically installing.
You can also run a different PL and DPL on encode and decode. Realistically, using alphanumeric, you can expect 50-80 conventional modes. One board is green, one is red.īoth versions of the board have the capability to store 256 modes, but this is assuming that you do not use the alphanumeric capability and that you have 16 LTR systems with 16 talkgroups each. The OPT-1225-PP is a less obnoxious series of tones. The easiest way to tell the difference is to power up the radio with the option board installed - the OPT-1225 will make an amusing multi-tone start up sound. There are two versions of this board, the OPT-1225 and OPT-1225-PP. makes a LTR option board which goes into either the P1225 or the M1225 which will make the radios capable of going up tp 256 channels. So far there is only one method we know of to open up the bandsplit of these radios (RSS >v3.1), along with the number of channels. This will no longer work with the newest version of RSS (3.1). Using RSS versions 1 and 2, Out of Band programming can be done by holding down the shift key for everything except the decimal place during frequency entry. If the micro-p were to be changed to a non-LS UHF processor (like maybe one scrounged out of another dead M1225) the radio would have to be re-aligned. To convert it back to a M1225 conventional radio, the microprocessor would have to be changed. This radio uses a masked processor and is not flashable. That's why it only does 2 conventional channels. The M1225LS has limited memory available.
Likewise, if the radio you have has been programmed by newer software than you posess, you will not be able to read/write it unless you get the same or newer version than what is in the radio. That is to say, once you program a radio with a newer version of software, there is no going back. audio in.Īn RSS note, the RSS for these radios is not backwards compatible. the input is switched by the PTT line from the accessory connector. Motorola did swap radios so you could use pin 5 BUT. Some very early M1225's would not let you put audio into pin 5. If you delete this option, you should be able to alpha-tag all the channels. However, we have been told that one of the greatest memory hogs is the Talk-Around button option. If you select this option, as long as you don't use the alphanumeric portion on every channel (or it will run out of memory) you can get 24 channels in. There is a selection in the RSS to make the radio 24 channels. The accessory connector pinout is the same as that of the SM50/120 radios. NOTE: You must use the keys along the top of the keyboard for this to work, not the keys on the numeric keypad. Using RSS versions 1 and 2, and 3.1 Out of Band programming can be done by holding down the shift key for everything except the decimal place during frequency entry.